AXIL MD 0283 E - Device Code Display; Reset Remote Control; Other Operations

ENG
Device Code Display
The device code is a 3-digit number and any one of the 3 digits can be
indicated:
1. Strike the device key which code no. You want to display.
2. Press and hold the [SET] key, in the mean time press the digit that
you want to display, such as 1,2,or3.
3. Release the both pressed keys
4. Count the times the LED blinks, and the blinking time is the digit.
If there is no blink, the digit is zero.
For example: for code 138
SET+1 (rst digit): LED blinks 1 time
SET+2 (second digit): LED blinks 3 times
SET+3 (third digit): LED blinks 8 times
Reset
Use the Reset function to erase all the set up data.
1.Press and hold the [SET] key.
2.Then press and hold the [0] key for more than 3 seconds.
3.Then release the both pressed keys, the LED will blink three then
o, your remote control got reset.
Others
After you have nished set-up, rst please press the device key (TV
or TDT…) on remote control that you want to use, and then operate
your remote control normally.