Axiohm A794 - Page 71

Chapter 6: Programming Information A794 Owner’s Guide
December 199966
Generate Pulse to Open Cash Drawer
ASCII ESC p n p1 p2
Hexadecimal 1B 70 n p1 p2
Decimal 27 112 n p1 p2
Value of n: 00, 48 (Decimal) = Drawer 1;
01, 49 (Decimal) = Drawer 2
Value of p1: 0-255
Value of p2: 0-255
Sends a pulse to open the cash drawer.
Formulas
The value for either p1 or p2 is the hexadecimal number multiplied by 2 msec to equal
the total time.
♦ On-time = p1 (Hex) x 2 msec
♦ Off-time = p2 (Hex) x 2 msec
Related Information
The off-time is the delay before the printer performs the next operation. Refer to cash
drawer specifications for required on and off-time.
Select Cut Mode and Cut Paper
ASCII GS V m GS V m n
Hexadecimal 1D 56 m 1D 56 m n
Decimal 29 86 m 29 86 m n
Value of m: Selects the mode as shown in the table.
Value of n: Determines cutting position only if m is 65 or 66.
m
Feed and Cut Mode
0, 48 Full cut (no extra feed).
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting position + (n times vertical
motion unit), and cuts the paper completely.
66 Feeds paper to cutting position + (n times vertical
motion unit), and performs a partial cut.
Range of m: 0, 48; 1, 49
65, 66 (when used with n)
Range of n: 0 – 255
Default of m, n: 0
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter m, the other requiring two parameters m and n.
The format is indicated by the parameter m.
Formulas
n times the vertical motion unit is used to determine the cutting position to which the
paper is fed.