To Next PageTo Next PageWhat to do if my Axiom Water System pump will not shut off?
If your Axiom Water System pump won't shut off, consider these potential causes: * There might be an air lock in the pump. Isolate the feeder from the system, then turn the purge/mixing valve to prime the pump. * There could be a leak in the system or pump. Inspect the system and repair any leaks. * The pressure controller might be faulty and need replacement.
What causes high pressure in my Axiom Water System?
High pressure in your Axiom Water System can occur for the following reasons: * The pressure controller is not adjusted to the proper setpoint. Adjust the pressure controller according to the manufacturer's recommendations. * The pressure controller is plugged. Replace the pressure controller and ensure the fluid in the tank is clean. * The pressure controller is faulty and needs replacement.
Why is my Axiom Water System operating noisy / rough?
Noisy or rough operation of your Axiom Water System can be attributed to: * The pump being overloaded and the pump pressure controller not cutting out. Replace the pump. * The feeder being plumbed with rigid pipe, causing noise to transmit. Plumb with PEX or a flexible system connection.
Why does my Axiom Water System pump cycle continually?
The pump in your Axiom Water System might cycle continually due to: * Air being removed from the system and the pump only making up fluid. No action is required. * A leak in the system. Inspect the system and repair any leaks. * A check valve or regulator installed between the System Feeder and the system. Remove the check valve or regulator.
Why won't my Axiom Water System pump start?
There are several reasons why your Axiom Water System pump might not start: * The fluid level in the tank might be low. Add the correct fluid and check for any system fluid loss. * A fuse might be blown. Check the fuse and replace it if needed (250V, 2.0 Amps). * There could be a problem with the power supply or breaker. Check the LED indicator light on the power cord, flip the breaker, or replace the power supply. * The power supply might be unplugged or have loose electrical connections. Ensure the power supply is plugged in and correct any faulty electrical connections. * The pressure controller might be out of adjustment. Adjust it according to the manufacturer's recommendations. * The pressure controller might be faulty and require replacement. * The pump itself might h...
Why is the pressure low in my Axiom Water System?
The low pressure in your Axiom Water System could be due to several factors: * The fluid level in the tank might be low. Add the correct fluid and check for any system fluid loss. * A fuse might be blown. Check the LED indicator light on the power cord and replace the fuse if necessary. * There could be a problem with the power supply or breaker. Check the LED indicator light on the power supply, flip the breaker, or replace the power supply. * The pressure controller might be out of adjustment. Adjust the pressure controller according to the manufacturer's recommendations. * The pressure controller might be faulty and require replacement. * The power supply might be unplugged or have loose electrical connections. Ensure the power supply is plugged in and correct any faulty el...
Details the five functions of the digital pressure controller and their operation for setting adjustments.
General| Brand | Axiom |
|---|---|
| Model | DMF150 |
| Category | Industrial Equipment |
| Language | English |
