Display Options & Channel Setup
Channel Setup
Each region has different broadcast channels. Your portable TV will scan for all
the channels in the area and remember each location. You can then go through
and add or delete channels individually as you prefer. When completed,
pressing the up / down channel buttons will take you through all of your
selected channels in sequence.
Note: If you scan for broadcast channels (Air) and then switch to Cable TV, you
will need to re-scan. Your TV tuner can
receive both analog and digital signals.
Press the ◄ ► buttons to select
.
Press the ▼ button to enter to sub-menu.
Press the▲▼ buttons to select the desired
sub-menu.
Antenna / Cable
Press the ▲▼ buttons to select
Antenna.
Press the ◄ ► buttons to select CATV or Air.
In the Air position, you can use the telescoping antenna or another external
antenna to pick up broadcast signals. See
Cable System submenu for CATV
settings.
Auto Scan
10
1. Press MENU.
2. Navigate across using ► to
select
.
3. Next navigate down using CH-
to
AUTO SCAN. Once green
box is highlighted, press ►.
4. Press ► to START TO SCAN.
Cable System
For cable stations, first set Antenna to CATV as above and then proceed
as follows:
Press the ▲▼ buttons to select Cable System and press the ◄ ► buttons
to select AUTO, STD, IRC, HRC.
Note: this item is only enabled when Antenna is set to CATV.
To Next Page
Loading...
Need help?
General
