14
AXIS 241Q/241S - Installation
ARP and Ping in UNIX/Linux
Assign your product with a unique IP address from a computer on your network, as
follows:
1. Acquire an unused IP address for the AXIS 241Q/241S from your network
administrator.
2. Connect the AXIS 241Q/241S to the network using a standard network cable.
3. Locate the serial number (S/N) found on the label on the underside of the AXIS
241Q/241S.
4. Start/restart the AXIS 241Q/241S. This must be done no later than 2 minutes after
entering the ARP and Ping commands.
5. Close the ARP/Ping session when ‘Reply from 192.168.0.125: ...’ (or similar) is
displayed (approximately 10-15 seconds).
6. Start a browser and enter the IP address in the Address/Location field.
7. Press Enter.
8. Enter a password for the root user (administrator).
9. The installation is now complete. Proceed to Using the video server, on page 16.
Syntax:
arp -s <IP Address> <Serial number> temp
ping -s 408 <IP address>
Example:
arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 192.168.0.125
To Next Page
Loading...
