Axis Camera Station S22 Appliance Series

To Next Page

To Previous Page

AXISCameraStationS22ApplianceSeries

Managethebuilt-inswitch

Thepowerrequestedismanuallyadjustedto20WforPoEclass4devices.Theswitchcanpower5PoEclass4devicesand3PoEclass

2devices.Thetotalpowerrequestedis(5x20)+(3x7)=121W.Theactualpowerconsumedis(5x15)+(3x5)=90W.Inthis

way,allconnecteddevicesareguaranteedenoughpowerandthepriorityislessimportant.

Settings

Congurenetworksettings

Youcanchangetheswitch’sIPaddress.Butformostcamerainstallations,werecommendusingthedefaultsettings.Thereasonfor

thisisthatasurveillancenetworkisnormallyisolatedfromothernetworks,forexampleacorporateLAN.Inthiscase,youwould

onlyusethesurveillancenetworktomanageandcollectsurveillancedevicesanddatafromthevideomanagementsoftware

installedontheserver.

1.Intheswitch’smanagementpage,gotoSettings>Networksettings.

2.Entertheconnectiontype,IPaddress,subnetmask,gateway,DNS1,DNS2,andhostname.

Note

Thefactorydefaultsettingsare:astaticIPconnectionwithaddress192.168.0.1andasubnetmaskwithaddress

255.255.255.0.

3.ClickSave.

Conguredateandtime

1.Intheswitch’smanagementpage,gotoSettings>Dateandtime.

2.Selectthecountryandtimezone.

3.Tosetthetimemanually,selectManualandmanuallyadjustthetime.

4.TosetupanNTPserver,selectNTPserverandentertheNTPserveraddress.

Note

NTPonlyworkswhentheswitchisconnectedtoanetworkandconguredwithInternetaccess.

Axis Camera Station S22 Appliance Series - Switch settings