Axis D3110 - Configure your device; Set up rules for events

AXISD3110ConnectivityHub
Configureyourdevice
Configureyourdevice
Setuprulesforevents
Tolearnmore,checkoutourguideGetstartedwithrulesforevents.
Triggeranaction
1.GotoSystem>Eventsandaddarule.Theruledeneswhenthedevicewillperformcertainactions.Youcanset
uprulesasscheduled,recurring,ormanuallytriggered.
2.EnteraName.
3.SelecttheConditionthatmustbemettotriggertheaction.Ifyouspecifymorethanoneconditionfortherule,allofthe
conditionsmustbemettotriggertheaction.
4.SelectwhichActionthedeviceshouldperformwhentheconditionsaremet.
Note
Ifyoumakechangestoanactiverule,therulemustbeturnedonagainforthechangestotakeeffect.
Detecttamperingwithinputsignal
Thisexampleexplainshowtosendanemailwhentheinputsignaliscutorshort-circuited.Formoreinformationaboutthe
I/Oconnector,seepage34.
1.GotoSystem>AccessoriesandturnonSupervisedfortherelevantport.
Addanemailrecipient:
1.GotoSystem>Events>Recipientsandaddarecipient.
2.Typeanamefortherecipient.
3.SelectEmail.
4.Typeanemailaddresstosendtheemailto.
5.Thecameradoesn’thaveit’sownemailserver,soithastologintoanotheremailservertosendmails.Fillintherestofthe
informationaccordingtoyouremailprovider.
6.Tosendatestemail,clickTest.
7.ClickSave.
Createarule:
1.GotoSystem>Events>Rulesandaddarule.
2.Typeanamefortherule.
3.Inthelistofconditions,underI/O,selectSupervisedinputtamperingisactive.
4.Selecttherelevantport.
5.Inthelistofactions,underNotications,selectSendnoticationtoemailandthenselecttherecipientfromthelist.
6.Typeasubjectandamessagefortheemail.
7.ClickSave.
6