Axis M3114-VE User Manual (English)

Other manuals for Axis M3114-VE

Questions and Answers:

E
erica72Aug 7, 2025
How to fix Axis M3114-VE when it cannot be accessed from a browser?
- S
  simpsonnathanAug 7, 2025
  If you cannot log in to your Axis Security Camera via a browser, and HTTPS is enabled, ensure that you are using the correct protocol (HTTP or HTTPS) when attempting to log in. If the IP address has been changed by DHCP, move the Axis product to an isolated network, or to one with no DHCP or BOOTP server and set the IP address again, using AXIS IP Utility or ARP/Ping. Open the Setup pages and disabled DHCP in the TCP/IP settings. If you encounter a certificate error when using IEEE 802.1X, synchronize the date and time settings in the Axis product with an NTP server for authentication to work properly.
R
Rick HerreraAug 11, 2025
What to do if my Axis M3114-VE Security Camera is accessible locally but not externally?
- V
  Valerie CastroAug 11, 2025
  If your Axis Security Camera is accessible locally but not externally, the issue may be related to router configuration or firewall protection. To configure your router to allow incoming data traffic to the Axis product, enable the NAT-traversal feature. You may also need to check the Internet firewall with your network administrator and verify if you need to configure the router settings.
J
Joel McdonaldAug 20, 2025
Why am I having problems setting the IP address on my Axis M3114-VE?
- S
  Sherry CurryAug 20, 2025
  You might be experiencing problems setting the IP address on your Axis Security Camera because the product is located on a different subnet, or the IP address is being used by another device. Contact your network administrator to obtain an IP address. Alternatively, there may be a possible IP address conflict with another device on the same subnet. Obtain a new IP address from the network administrator and reinstall the product.
M
Michael HoustonAug 25, 2025
What to do if my Axis M3114-VE's Motion Detection triggers unexpectedly?
- C
  carmen53Aug 25, 2025
  If the Motion Detection on your Axis Security Camera triggers unexpectedly, it might be due to changes in luminance. Lower the sensitivity setting to avoid problems with luminance.
X
xsawyerAug 28, 2025
What to do if no images are displayed on the Axis M3114-VE Security Camera web page?
- C
  Charles BurkeAug 29, 2025
  If no images are displayed on the web page of your Axis Security Camera, it may be due to the installation of additional ActiveX component being restricted or prohibited. Set the browser to allow ActiveX controls.
H
hcampbellSep 1, 2025
What does it mean if the Status and Network indicator LEDs are flashing red rapidly on my Axis M3114-VE Security Camera?
- A
  Allen SmithSep 1, 2025
  If the Status and Network indicator LEDs are flashing red rapidly on your Axis Security Camera, it indicates a hardware failure. Contact your Axis reseller.

Axis M3114-VE Specifications

General

Camera Type	Fixed Dome
Focal Length	2.8 mm
Aperture	F2.0
Day/Night Functionality	Yes
IK Rating	IK08
Lens Type	Fixed
Video Compression	H.264
Frame Rate	30 fps
Power over Ethernet (PoE)	Yes (IEEE 802.3af)
Operating Temperature	50 °C
Storage	microSD card