18
AXIS P1346/-E/AXIS P1347 - Video & Audio
Stream Profiles
There are four pre-programmed stream profiles available for quick set-up. These settings can be adjusted and new customized
profiles can be created. Each profile has a descriptive name, describing its usage and/or purpose. The profiles can be accessed
from the Live View page.
• To create a new stream profile, click Add... to bring up the Stream Profile Settings dialog.
1. Enter a unique name and a description for your profile.
2. Select a Video encoding (H.264 or MJPEG) from the drop-down list.
3. Modify the stream settings under the Image, Audio, H.264 and MJPEG tabs. See Video Stream, on page 16.
4. Click OK to save the profile
• To copy an existing stream profile, click Copy... and enter a new name. Change the stream profile settings as above.
• To modify an existing stream profile, click Modify... and change the settings as above. The original settings for the
pre-programmed profiles can always be restored by clicking Restore.
• To remove a stream profile, click Remove. Pre-programmed profiles cannot be removed.
Camera Settings
This page provides access to the advanced image settings for AXIS P1346/-E/AXIS P1347.
Capture mode
Capture mode defines how image data is taken from the image sensor prioritizing either frame rate or resolution. The capture
mode is set the first time the camera is accessed, see Configure capture mode, on page 10.
Capture modes for AXIS P1346:
• 3 MP (4:3 format) at 20 fps
• 2 MP (4:3 format) at 30 fps
• HDTV 1080p (16:9 format) at 30 fps
Capture modes for AXIS P1347:
• 5 MP (4:3 format) at 12 fps
• 3 MP (4:3 format) at 20 fps
• 2 MP (4:3 format) at 30 fps
• HDTV 1080p (16:9 format) at 30 fps
If the capture mode setting is changed, most other settings, for example view areas, motion detection windows and events,
will be removed or reset. Stop all video streams before you change the capture mode.
View Areas
Check the box Enable View Areas to enable the camera’s View areas and digital PTZ functionality.
Image Appearance
Color level - Select an appropriate level by entering a value in the range 0-100. Lower values mean less color saturation,
whilst the value 100 gives maximum color saturation.
Brightness - The image brightness can be adjusted in the range 0-100, where a higher value produces a brighter image.
Sharpness - Controls the amount of sharpening applied to the image. A sharper image might increase image noise especially
in low light conditions. A lower setting reduces image noise, but the image would be less sharp.
Contrast - Adjust the image's contrast by raising or lowering the value in this field.
To Next Page
Loading...
Need help?
General
