Boats operated in salt water, brackish water or polluted fresh water
must be thoroughly rinsed with CLEAN, fresh water after EACH outing.
The corrosive properties of these types of water will cause damage that
is not covered under warranty! Hardware—even hardware chose for its
anti-corrosive properties—that is damaged by salt/brackish/polluted water may eventually fail, which
could result in serious injury or death to persons on-board.
The following areas, where equipped, should always receive special attention when cleaning
after boating in salt/brackish/polluted water:
1 = Bow grab handles 2 = Front cup holders
3 = Vent covers
1 = Windshield bracket 2 = Throttle
3 = Subwoofer plate 4 = Seat mount
1 = Cup holders (all on both
sides of interior)
2 = Grab handles
3 = Center plate
4 = Ski pylon
Also, tower hinges
Axis
Owners
Manual
2019
Page 158
2
2
1
1
3
1
2
3
4
4
2
3
1
To Next Page
Loading...
Need help?
General
