6
Before you install the child restraint make sure that the headrest is at the
correct height for your child. The harness, when correctly installed, should be
routed from the back of the seat to the front and pass just above your child’s
shoulders.
In order to adjust the height of the headrest and harness you will rst need to
detach the harness. Press the harness adjuster button (E) and pull forward on
the shoulder straps (not the shoulder pads) to completely loosen the harness.
Open the zipper (N) on the back of the seat cover.
Unhook the shoulder straps from the yoke (R) at the back of the child restraint
and pull the two shoulder straps through to the front of the seat.
Detach the shoulder pads (B) on the back of the seat and pull the two shoulder
pad straps through to the front of the seat.
Squeeze the plastic clip and gently pull the headrest free from the seat.
Reposition the headrest at one of the three heights that best suits your child.
Push the bottom of the headrest until the plastic clip locks in place.
Thread the shoulder pad straps out through the holes in the headrest to the
back of the seat and reconnect the two shoulder pad straps.
Route the harness straps through the shoulder pads and out through the holes
in the headrest to the back of the seat. Reconnect the harness straps to the
yoke. Make sure the harness is routed between the seat and the support leg.
Make sure the height is correct by placing your child in the seat.
2
3
4
5
6
7
8
9
Adjusting the headrest and harness height
Rear-facing 9-25 kg with seat belt & tethers
10
11
To Next Page
Loading...
