8
Detach the tether strap’s metal clip from the child restraint, press the grey
button (M) and pull the loop end out to maximise the length of the strap.
To attach the tether straps to an anchor point, wrap the strap around the
chosen anchor point and pass the metal clip through the loop.
Reattach the metal clips to each side of the child restraint and pull the free
ends of both tether straps until you have tensioned them. Pull each strap once
again as hard as possible to ensure the child restraint is secured tightly.
Unfold the support leg (O) out to its maximum angle. Pull out the top latch
(P) to release the upper part of the support leg until it reaches the oor. If the
support leg does not reach the oor, repeat with the lower latch (Q).
It is important that you check that the support leg is at an angle over 80
degrees from the back of the seat. You could check this by ensuring that the
support leg is further away from the seat than the vertical line.
Now rmly pull the straps on both sides of the seat to make sure that your seat
is fully secured.
If you have installed Wolmax in the back seat you can now move the front seat to a
comfortable position.
Note: The back of the child restraint may, but does not need to be in contact with
the back of the front seat.
Insert the seat belt tongue into the vehicle’s seat belt buckle. Pull the seat belt
until all slack is removed along the seat belt route. Secure both the lap and
shoulder belt in the lock-o closest to the vehicle’s seat belt buckle.
In the lock-o on the opposite side, only the lap belt should be secured.
16
17
Attaching the tether straps
18
19
20
21
22
23
To Next Page
Loading...
