9
Placing your child in the seat
Press the harness adjuster button (E) and pull forward on the shoulder straps (not
the shoulder pads) to completely loosen the harness.
Press the red harness release button on the buckle and unfasten the harness.
Place your child in the car seat. Put your child’s arms in between the shoulder
straps so that the straps are hanging over the chest and stomach.
Pull the shoulder straps together and insert the harness tongues into the
crotch buckle.
Pull the harness adjustment strap (F). It’s important that you always pull the
harness straight and central when you tighten the adjustment strap. Failure to
pull the harness correctly may cause the strap to jam in the mechanism.
Before placing your child in the seat, ensure you have adjusted the headrest and harness
to the correct height for your child (see steps 2 To 11)
26
27
28
29
30
When installing the Wolmax on a back seat, wrap the tether straps through
either the rear of the front seat rails (i), or the hinge of the front seat (ii).
When installing the Wolmax in the front passenger seat, the tether straps
should be wrapped around the nearest suitable anchor point (i) that will allow
the straps to be tightened fully. Anchor points set further back (ii) can be used
and if need be the straps can be crossed over (iii) and even looped together (iv).
WARNING: Never attempt to remove the child restraint whilst your child is still
seated in it.
Open the belt lock-o clips (L) on both sides of the child restraint.
Release the vehicle’s seat belt buckle (i) and completely remove the seat belt
from the child restraint. Collapse the support leg (O). Unhook the tether straps’
(K) from the child restraint and remove the child restraint from the vehicle. Finally
unwrap the tether straps from the vehicle’s anchor points and then re-hook the
straps on to the child restraint.
TIPS FOR Attaching the tether straps
Removing the child restraint from the vehicle
24
31
25
To Next Page
Loading...
