7
Open the belt lock-o clips (L) on both sides of the Wolmax child restraint. Fully
lengthen the seat belt until the lap section of the belt is at least 70-80cm (27-32
inches) long. Feed the seat belt through the seat belt slot (D), between the seat
cover and seat body until the belt comes out through the seat belt slot on the other
side. If you prefer, you can instead feed the seat belt through the seat belt slot (D),
then over the top of the seat belt cover and then through the seat belt slot on the
other side.
15
Fastening the vehicle seat belt
The easiest way to lift the Wolmax into the vehicle is with its back rst. Place
the child restraint in the vehicle with the back of the restraint facing the front
of the vehicle.
The heels (H) should be sitting over the edge of the vehicle seat. The indented
vertical line (I) on the heel should align vertically with the end of the vehicle’s
seat. If installing in a small vehicle, or if your child does not require extra leg
room, you can instead place the heel upon the vehicle’s seat this will also achieve a
more reclined position.
Note: When installing Wolmax in the front seat it is possible, but not crucial, for the
back of the restraint to have contact with the dashboard.
To adjust the angle of the child restraint, rotate block (G) into one of the two
tilt positions. Always choose the most upright position as possible, however
your child must be able to hold their head up on its own, and there should be
enough recline to ensure your child’s head does not fall forward when sleeping. The
rule of thumb is that the older the child grows, the more upright the seat can be
installed. Please note that once the installation of the Wolmax is complete, it will be
somewhat more reclined as it sinks into the vehicle’s seat from tightening seat belts
and tether straps.
Positioning the child restraint
12
13
14
Never install a child restraint in a passenger
seat where an active airbag is tted.
To Next Page
Loading...
