42
AXTON C109 C209 C409 C509
Rated power output stereo (at 13.8V) at 4 Ohms (W RMS) min. 1 x 300 2 x 60 2 x 120 4 x 60
Rated power output stereo (at 13.8V) at 2 Ohms (W RMS) min. 1 x 420 2 x 95 2 x 180 4 x 90
Rated power output bridged (at 13.8V) at 4 Ohms (W RMS) min. n. a. 1 x 180 1 x 350 2 x 190
Frequency response (Hz) 10 - 30'000 10 - 30'000 10 - 30'000 10 - 30'000
Total Harmonic Distortion (THD) at 4 Ohms (%) < 0.05 < 0.05 < 0.05 < 0.05
Signal to noise ratio (dB) > 95 > 95 > 95 > 95
Channel separation (dB) n. a. > 55 > 55 > 55
Crossover slope (dB/oct) 12/12 12/12 12/12 12/12
Crossover range low/highpass state-variable (Hz) HPF
od. LPF 10-60/30-300 40-240 40-240 40-240
Recommended power cable cross-section with approx. 5 m (mm²) 20 8-20 20 20
Input impedance (kOhms) 47 47 47 47
Input sensitivity (V) 0.2 - 9 0.2 - 9 0.2 - 9 0.2 - 9 V
Damping factor @4 Ohms > 250 > 250 > 250 > 250
Thermal cut-off (°C) 80 80 80 80
Fuse (A) 2 x 25 1 x 25 2 x 25 3 x 25
Recommended main fuse on battery side with 20mm²
power cable (A) 60 30-40 60 60
Dimensions (W x H x L in mm) 311 x 53 x 210 256 x 53 x 210 256 x 53 x 311 256 x 53 x 311
42
SPECIFICATIONS
I
Specifications subject to change without notice.
AXTON is a registred trademark of ACR AG, Bohrturmweg 1, CH-5330 Zurzach, Switzerland.
To Next Page
Loading...
