5
AC216Bi OPERATION
General Operation
Press or any other button to turn the unit on. Press and
hold
to turn the unit off.
Press MODE to select between Tuner, Disc, Auxiliary
Input, USB, iPod, Bluetooth or Pandora modes. Modes of
operation are indicated in the display. USB, iPod, Bluetooth
and Pandora modes will only appear when connected.
The radio frequency (tuner mode) or MP3 title/track
information (USB mode) will be shown by default. Press
DISP to toggle back and forth between the default display
and clock display.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located behind the face
plate.
Press OPEN to open the face plate, then pull away to
remove. To re-install, insert the right side of faceplate first
then push the left side in to secure.
Press DISP to display the clock, then press and hold DISP
until the time begins to flash. Press TUNE
ll
to adjust
the minutes or TUNE
nn
to adjust the hours.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc.
Adjust volume using the volume knob (00-46).
While the unit is powered on, press
to silence the audio.
Press
again or rotate the volume knob to restore audio
volume.
Power On/Off
Mode
Display
Reset
Faceplate Removal
Setting the Clock
Auxiliary Input
Volume
Mute
To Next Page
Loading...