Optimization and
Customization
The VX-5 power amplifier is configured from the
factory for flexible operation in most audio systems.
However, in certain installations it may be desirable
to change the factory default settings or create an
alternate control connection.
Display Brightness
Normally the brightness of the status LED is
controlled by other linked components connected to
the VX-5 via the AyreLink communications port.
However if there are no other AyreLink components
available, the brightness level may be set while the
unit is in the configuration mode.
To enter the configuration mode, turn the amplifier
“Off” with the rear-panel power switch for at least
one minute. Then press and hold the front-panel
button while switching the power back “On”. The
status LED will flash violet to indicate the amplifier
is in configuration mode.
The unit will remain in configuration mode for ten
seconds. During that time, pressing the front-panel
9
To Next Page
Loading...
Need help?
General
