In case the software installation stops midway and doesn’t progress,
make sure to pause your antivirus and try to install again.
After the installation is done, plug in the USB cable of the keypad in PC
and then launch the Azeron software.
If you are not sure if your PC has the USB3.0 motherboard drivers installed, then we
would suggest to use USB 2.0 port to avoid unpredictable behavior of the keypad
recognition.
Also if you are using USB hub, the keypad may flicker and have power shortage. So
make sure to use USB hub that can provide enough power or plug in the keypad directly
in PC motherboard.
To Next Page
Loading...
