LOWRIDER OWNER’S MANUAL PAGE 13
01-2018
Prolonged exposure to machine vibration may cause tingling or numbness in
the fingers and hands. Use of gloves and limits to operator vibration exposure are recommended to
prevent such symptoms. The operational hand/arm vibration level of this machine is less than
2.5m/s2.
Per OSHA standards, ear protection is not required, but is suggested during
operation.
All machines are equipped with tamper proof fuel systems. If a fuel problem
exists, contact an authorized service center.
All machines are equipped with a multi-function maintenance meter. The
functions include the following: hours, service alert and tachometer; see ENGINE MAINTENANCE
METER instructions on pg 19.
Engine speed not to exceed 3400 RPM.
This machine is supplied with a centrifugal clutch. When the engine RPM is
lower than 1500 RPM, the clutch will disengage; pad will stop.
This machine is not suitable for picking up hazardous dust.
Do not use this machine on surfaces with a gradient exceeding 2%.
All machines are equipped with a multi-function maintenance meter. The
functions include the following: hours, service alert and tachometer; see ENGINE MAINTENANCE
METER instructions on pg 19.
Make sure the operator receives adequate instruction before operating the
equipment.
To Next Page
Loading...
