LOWRIDER OWNER’S MANUAL PAGE 12
01-2018
LOWRIDER OPERATION
The LowRider must be secured on a level surface when transporting in a
vehicle. Secure the machine in the vehicle so it cannot move or bounce during transporting;
damage may occur to the machine and/or the vehicle and surrounding objects.
This propane burnishing machine is designed for buffing and polishing VCT and concrete floors;
with its low 3 ¾” profile, the LowRider will burnish under racks and hard to reach areas. The
LowRider includes an advanced composite polymer pad driver. No other application of this
equipment should be attempted nor is recommended. Call Aztec (800) 331-1423 for any additional
application questions.
The LowRider is available and is available in 21”, 24” and 27” pad sizes, with optional upgrades
including Dust Control and Spray Mist options. Call (800) 331-1423 for more information.
First, refer to the SAFETY INFORMATION on pgs 3-9, and complete the BEFORE OPERATION
CHECKLIST on pgs 10-11.
Never tilt back machine while engine is running. Objects may fly out from
underside of machine and damage can occur to the machine, furniture, buildings and/or personal
injury.
The engine and exhaust become very hot during operation. Keep the engine
at least 1 meter (3 feet) away from buildings and other equipment. Keep flammable materials away,
and do not place anything on the engine while it is running.
Factory engine speed is set at approximately 3400 RPM. Tampering with the
settings will void the warranty and injury can result. Refer to the equipment specifications.
Continuous exposure to high noise levels can cause hearing loss. Although
not required by OSHA based on engine volume, hearing protection is recommended while the
machine is in operation. In compliance with OSHA regulations, the operational weighted sound level
of this machine is less than 89dB(A).
Do not use machine with a damaged or disintegrated pad, to avoid excess
vibration.
To Next Page
Loading...