LOWRIDER OWNER’S MANUAL PAGE 15
01-2018
LOWRIDER – GETTING STARTED
Responsibly dispose of used pads; always dispose of old materials with the
environment in mind.
Do not operate the machine in one location for more than a few seconds; this
will damage, or “burn” the finish.
The LowRider is not designed for scrubbing operations.
1.) Once all of the BEFORE OPERATION CHECKLIST on pgs 10-11 is completed, open the
LPG tank valve (counter clockwise).
2.) To install pad, tilt machine back and secure in place. To tilt back the machine safely, refer to
TRANSPORTING THE MACHINE on pg 17-18.
3.) Once the machine is securely tipped back in position, remove the pad. Remove and
responsibly dispose of the old pads. Be sure to center the new pad in the center of the pad
holders. For brushes, turn clockwise to remove, and counter clockwise to install new brushes.
4.) Return machine back to level position before proceeding.
5.) Adjust the machine handle to comfortable position using pin provided to secure in place.
6.) Open the LPG tank valve by turning counter clockwise.
7.) Set the throttle control switch to the SLOW position.
8.) Turn key to START position until engine starts. Starter should not be engaged for more than
10 seconds at a time. If hard starting is a problem, carefully review BEFORE OPERATION
CHECKLIST on pgs 10-11. As soon as engine starts, immediately move throttle cable to
SLOW/idle position or into desired engine speed. The clutch will disengage when throttle is
moved to the SLOW position.
9.) Follow the machine in a moderate walking speed; keep moving forward.
10.) When your day is done, carefully complete the LOWRIDER CLEAN UP steps on pg 17.
Always clean and maintain your equipment, and keep accurate records of service and
maintenance to maintain the warranty. Refer to the MAINTENANCE SCHEDULE on pg 22.
11.) To properly store equipment, refer to the STORAGE AND HANDLING SAFETY
INFORMATION on pg 8.
To Next Page
Loading...