User Manual
Page 10 of 40
To create a HomePlug AV network using Simple Connect:
Step 1
Plug your HomePlug AVs side by side where
you can easily observe the LED behavior.
Upon connection, the LEDs will blink
simultaneously and then the Power LED
lights on steadily.
Step 2
Press Simple Connect for two seconds on
HomePlug X. After you release the button,
the Power LED will blink. If the Power LED
did not blink, press Simple Connect
again for two seconds.
Note:
Note:Note:
Note: Do not press Simple Connect for more than 2
seconds.
To Next Page
Loading...
