User Manual
Page 15 of 40
Joining an Existing HomePlug AV Network
To enable a new device to join an existing network, Simple Connect will copy the
Private Network Name of the existing network to the new HomePlug AV. If you pressed
Simple Connect from multiple HomePlug AVs, only the signal from the first two devices
will be processed.
To join an existing HomePlug AV network using Simple Connect:
Step 1
Plug HomePlug Z near a HomePlug from an
existing network. Make sure you can easily
observe the LED behavior.
Upon connection, HomePlug Z’s LEDs will
blink simultaneously and then the Power LED
lights on steadily.
Step 2
Press Simple Connect for two seconds from
a HomePlug AV in an existing network. After
you release the button, the Power LED will
blink. If the Power LED did not blink, press
Simple Connect again for two seconds.
Note:
Note:Note:
Note: Do not press Simple Connect for more than 2
seconds.
To Next Page
Loading...
Need help?
General
