User Manual
Page 16 of 40
Step 3
Press Simple Connect for two seconds
on HomePlug Z. After you release the
button, the Power LED will blink. If the
Power LED did not blink, press Simple
Connect again for two seconds.
Make sure to press Simple Connect on
HomePlug Z within two minutes after you
press Simple Connect from the existing
network.
The LEDs on both devices will switch off
and on twice to signify that they are
searching for another device to pair with.
Note:
Note:Note:
Note: Do not press Simple Connect for more than
2 seconds.
Step 4
To confirm if the connection was
established, check the LEDs. The Power
LEDs and the Powerline Activity LEDs
on all HomePlugs are on.
To Next Page
Loading...
Need help?
General
