3.2 Wi-Setup Wizard Steps
Whatever which wireless configuration you would set up,
the first scene of WiFi-AP Solo Wizard is “Select
Operation Mode” dialog that shows as right picture. You
could select either station or AP mode from the first step.
For Ad-hoc and infrastructure type configuration, you
should select Station mode. The software access point
configuration could be archived by select AP mode.
l Station
Set the operation mode to be “Station”. Follow steps
in section 4.3.
l AP
Set the operation mode to be “Access Point”. Follow steps in section 4.4.
l Next
Go to next step of selected mode.
l Cancel
Give up WiFi-AP Solo Wizard. The default wireless configuration will be automatically
applied as “Infrastructure” type of Station mode if user won’t set it up here.
3.3 Station Mode Configuration
Two types, infrastructure and ad-hoc types, of station mode are provided here.
l Infrastructure
Configure the wireless as infrastructure type network.
Follow steps in 4.3.1 Build Infrastructure type network.
l Ad-Hoc
Configure the wireless as Ad-Hoc type network. Follow
steps in 4.3.2 Build Ad-Hoc networking mode network
l Back
Go back to previous step – Select Operation Mode.
l Next
Go to next steps of selected type.
To Next Page
Loading...
Need help?
General