Only basic settings are included in following steps. Less-experience users could apply this
kind setup to archive access point setup. Fundamental security setting is included.
l Back
Go back to previous step ~ Select Operation Mode
l Next
The next step is dependant on the option user select:
l Cancel
Give up current WiFi-AP Solo Wizard setup and roll back to previous configuration.
3.4.1 Software AP setting
For Software AP mode, the basic security function only request two types network/password
key to provide WEP encryption.
Wireless Network Properties
l Network Name (SSID)
The service serve identify of this access
point. The length of the self-naming does
not exceed 32 characters.
l WEP Encryption
n Enable: The joined wireless station should
have same network/password key with this
access point.
n Disable: no network/password key is
required for joined wireless station.
l Back
Back to previous step ~ Setup a Wireless
Network
l Next
The next step is dependant on the decision of WEP to be either Enable or Disable.
n WEP Enable: You should prepare network/password key for WEP. Go to Wireless Network Security.
n WEP Disable: The access point is set as an opened hot-spot. Anyone could join this access point
and connect to internet.
To Next Page
Loading...
Need help?
General