B-TEC IR-B02 User Manual

IR-B02 Page 10
equipment and facility engineering
6. Troubleshooting
Problem:
Cause:
Troubleshooting:
Uneven baking
 The emitter is not as high as the
repaired surface
 Adjust the emitter to allow it to be
as high as the repaired surface
Small pores on the
baked surface
 Too near between the emitter
and the repaired surface
 Insufficient Preheating time
 Fast thinning agent included in
the paint
 Increase the distance
 Increase the preheating time
 Use standard or slow thinning agent
Poor curing or
transparent coating
 Too far between the emitter and
the repaired surface
 Insufficient baking
 Too thick coating
 Make the machine closer
 Increase the baking time
 Thin the coating
Difficult stains
 Too long baking
 Too near distance
 Shorten the baking
 Increase the distance
Fuzzy Edge
 The repair surface is too large
 Curing in two steps
 Move the device for second step
 Preheating for first time and do not
use preheating for second time
For optimal baking performance, we recommend that users should work out the suitable operating
procedures, baking time and distance according to the local natural conditions, working environment
and the types of paints.
Above specifications, exterior or diagrams are descriptive and subject to revision. If there are any
discrepancies or changes, actual products shall prevail without otherwise notification.

B-TEC IR-B02 Specifications

General

Brand	B-TEC
Model	IR-B02
Category	Dryer
Language	English