EasyManua.ls Logo

b'Twin E-LD500 - MOTOR; BATTERY AND CHARGER; Battery and Charger Details

b'Twin E-LD500
209 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 9
MOTOR
the sound pressure level expressed in dBA at the rider’s ear position is less than 70 dB (A).
BATTERY AND CHARGER
All batteries in our electric bikes use Lithium-Ion cell technology and have no memory e󰘯ect. The battery should be recharged after
each use.
Charge the battery fully before using for the 󰄈r󰄋 time.
Battery Charger
36 V / 14 Ah battery*
Input: 100-240V
Output: 42V
* Your 36 V battery is inactive at the time of purchase. Plug in your charger to activate it. Your battery is guaranteed for up to 500
charge cycles (1 cycle = 1 charge/discharge cycle) subject to compliance with 󰘵orage conditions and conditions of use. It’s impor-
tant to follow the in󰘵ructions outlined on the battery charger label.
User precautions
Do not expose to temperatures above 50°C.
< +10°C +10°C / 50°C > +50°C
+10°C
+25°C
Storage conditions: It is important to 󰘵ore the charged battery in a cool (between +10°C and
+25°C), dry place, out of direct sunlight.
<+10°C +10°C / +25°C +25°C
+10°C
+40°C
Charge your battery in a dry place at a temperature between 10°C and 40°C.
< +10°C +10°C / +40°C +40°C
Caution: In exceptional conditions, the controller can get very hot.
Do not dismantle.
Dispose of the battery in an appropriate container. Return the used battery to your neare󰘵
Decathlon 󰘵ore for recycling.
Risk of 󰘰re.
Risk of electrocution.
Handle with care. Impact sensitive.
Never short-circuit the battery by connecting the positive and negative terminals.
8 Di󰄋ance indicator
9
Units:
kilometres or miles
10
Lighting indicator:
Appears on the screen when the lights are on
11
Five battery levels.***
When the battery level is low, the indicator 󰘵arts 󰘱ashing.
12
Additional battery and sy󰄋em information:
Indicates the battery charge level as a percentage
Setting
Hold the «Lighting» button down for a few seconds to enter or quit the settings
Brie󰘱y press the «Lighting» button to display the di󰘯erent settings
Brie󰘱y press the «+» and «-» buttons to display the di󰘯erent adju󰘵ments.
SET 1: Choice of units (km/h or mph)
SET 2: Standby timer setting (in minutes)
* Under te󰘵 protocol conditions, for a rider weighing 75 kg with tyre pressure of 4 bar and following the 10 guidelines. ** Speed
display accuracy is +/-2%. *** Check the battery charge display when you 󰘵op; you may notice a big reduction in charge level
when using high pedal-assi󰘵 mode.

Table of Contents