B2 Audio SLD5K - Speaker Wiring - Single Amp; Strapped Control Panel Setting; Master; Slave

8
SLD5k
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF PHASESUBSONICGAIN
BASS
SLAVE
OUTPUT
MASTER
INPUT
SLAVE
INPUT
R
L
0.2V
6V
10Hz 50Hz 0dB
9dB
30Hz 90Hz 35Hz 250Hz 0 180
MASTER
SPEAKER
*If unstrapped, set as Master.
(Unpressed )
Speaker Wiring Diagram - single amplifier
Speaker impedance 1 Ohm ~ 8 Ohm
Loads under what is specied will cause excessive heat & the amplier
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 1 ohm is not warranted!
Speaker Impedance 1~ 8 ohm
Strapped control panel setting
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF PHASESUBSONICGAIN
BASS
SLAVE
OUTPUT
MASTER
INPUT
SLAVE
INPUT
R
L
0.2V
6V
10Hz 50Hz 0dB
9dB
30Hz 90Hz 35Hz 250Hz 0 180
MASTER
SPEAKER
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF PHASESUBSONICGAIN
BASS
SLAVE
OUTPUT
MASTER
INPUT
SLAVE
INPUT
R
L
0.2V
6V
10Hz 50Hz 0dB
9dB
30Hz 90Hz 35Hz 250Hz 0 180
MASTER
SPEAKER
*Set slave as slave, button pushed in.
*Leave Master unpressed
HEAD UNIT