A car seat (L) and set of adaptors (M) are included to complete the travel
system.
1a. Remove the seat unit from the chassis to t the adaptors.
Line up the adaptors with the chassis housing and press downwards.
Listen for a “click” to signal correct assembly.
1b. Place the car seat (L) onto the adaptors. Push down to “click” into place.
Lift by handle to ensure car seat is secure.
Alternatively, attach the adaptors to the car seat rst and then attach the
car seat to the chassis.
WARNING! Never attach the car seat forward facing.
M
1
2
5. Insert the bumper bar (E) into the seat unit slots ensuring that the release
buttons are on the outside and you hear a “click”.
Give the bumper bar a tug to ensure it’s securely in place.
To remove the bumper bar, simply press the release buttons on either or
both sides and lift up.
4. Insert the seat liner (J) into the seat unit to add extra comfort for baby.
Travel System
8 25
Pram Mode
J
E
L
To Next Page
