Bacharach Fyrite INTECH - Quick Start Guide Manual

P/N: 0024-9513
Revision 0
February 23, 2016
COMBUSTION GAS ANALYZER
QUICK START GUIDE
PREPARE CONFIGURE MAINTAIN
Review funcons and locaons of
key components (1 through 20)
Connect the probe (14 to 11, and
15 to 13)
Turn on the instrument (9)
Verify power (1)
Access and navigate the menus Replace sensors as needed
1 Display with backlight
2 Funcon keys
3-6 Navigaon keys
7 Enter key
8 Escape key
9 Power/backlight key
10 Run/hold key
11 T-Stack port
12 USB port
13 Sample gas port
14 Sample gas
thermocouple (T-Stack)
connector
15 Sample gas hose
16 USB cable (Oponal)
17 Locaon of oponal
NOx filter
18 Water trap and
filter assembly
19 Probe handle
20 Probe tube
Select fuel type
Use default configuraon values or
navigate to Setup Menu to set
combuson test parameters
Calibrate as needed
Replace baeries as needed
Replace water trap (18) filter as
needed
Baery
Compartment
T-STACK
GAS
USB
Leave Top
Port Open
CALIBRATION GAS
500 PPM CO
FLOW METER
This quick start guide provides basic infor-
maon. For safety warnings, addional
instrucons, and more detailed informa-
on, refer to the Configuraon and Opera-
on manual (part number 0024-9486)
available at www.MyBacharach.com.
T-STACK
GAS
USB
BOTTOM
VIEW
Filter
Wait for warm-up to complete
Full
Medium
Low
Replace
O
2
Cap
O
2
Sensor
Slot
Nub
CO
Cap
Printed Circuit Board
CO Sensor
Open
Closed