12 Instruction 3015-4149
SECTION 6
Powering Up the Monitoring System
(Warm up time is 15 minutes)
Start up checkpoints:
• All buttons on RDM800 “chirp” when pressed. (Contact the factory if they do not “chirp”)
• DO NOT plug the gas-sample inlets of any unused zones. During start up the software will pull a
vacuum test to verify the number of zones and a plugged zone will give a false count
• Communication connection between HGM300 and RDM800
• Check node address for the HGM300 (or multiple HGM300s)
• Terminator positions
To Next Page
Loading...
