Bacharach Parasense 3300RM2 - Page 4

iv
Operation & Maintenance Manual
Doc Ref. MN3300RM2 Rev. 5
REPLACING THE NETWORK MODULE (INC. INSERT PLATE) .................................................... 5-9
REPLACING A SAMM MODULE .................................................................................................... 5-10
REMOVING THE STYX MODULE ................................................................................................. 5-11
REPLACING THE STYX MODULE ................................................................................................ 5-12
REPLACING THE POWER SUPPLY MODULE ............................................................................. 5-13
REPLACING THE POWER INPUT MODULE ................................................................................ 5-14
TESTING MODES .......................................................................................................................... 5-15
CALIBRATION CHECK .................................................................................................................. 5-15
SYSTEM TEST ............................................................................................................................... 5-17
AIR FLOW....................................................................................................................................... 5-19
6 SPECIFICATION .............................................................................................................................. 6-1
...................................................................................................................................... A-1
3300RM2 GENERAL ARRANGEMENT (PM1940) ......................................................................... A-1
3300RM2 WIRING SCHEMATIC (PS0716) ..................................................................................... A-2
3300RM2 PANEL MOUNTING DETAILS (PM1951) ....................................................................... A-3
Revision
Details
Checked
2-3:
September 2013
System fault and fault messages section revised. Various changes
to module replacement instructions
2-4:
November 2013
System test updated. Calibration details removed, photos updated.
2-5:
November 2013
Page 3-9: area mode: configurable number of samples changed to
(between 1 and 9)
2-6:
December 2013
Multiple changes throughout entire manual
2-7:
March 2014
All display screenshots updated
2-8:
October 2014
Styx replacement procedure updated. Appendix: PM1940 and
PM1951 revised
2-9:
October 2015
Page numbers corrected. Appendix PM1940 and PS0716 updated
to latest revision
3-0:
9
th
Nov 2015
Appendix: PS0716 revised. Door and network module replacement
procedure updated. Photos updated to show correct wiring
configuration on J17 of network module. Checked box added to this
table. Multiple corrections
AK
3-1:
17
th
May 2016
Quality Management logo added
AK
4-0:
1
st
Feb 2017
System Test information re-worded to clarify its purpose and
changed number of reservoir bag valve turns from 2 to 1.
Updated Parasense Inc. address details. Stepwise branding
removed.
JB
4-1:
9
th
March 2017
Calibration check section added.
AK
4-2:
21
st
March 2018
Parasense logo updated throughout manual and drawings
JB
4-3
25
th
October
2018
Webpage screen shot updated
TS
5
March 2020
Updated addresses
JH