Fold up the steps as required and when fitting in place remove a small amount of riveted plastic strip
from the frame sides where the steps will fit to achieve a snug fit against the frame side. Note the
straight leg and handing on the rear steps.
Build the ladder in the etch and when the rods have been fitted, remove and clean up excess wire and
the bracing pieces that are no longer required. Again using photographic evidence trim ladder to the
length required. On the long ladder the support legs are twisted through 90 degrees and fit flush against
the rear buffer beam.
Bend rear guard irons to shape.
Rear of axle boxes removed
Tender chassis
To Next Page
Loading...
