ASSEMBLING YOUR BLENDER
Before assembling your Fitness Blender wash all parts, except for motor base, in
warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the valve
for cleaning (see Cleaning Your Blender section). To prolong the life of your
smoothie maker, do not wash parts in the dishwasher.
1. Screw blade base on the bottom of the blending jar by twisting the blade base
counter-clockwise until tightened. Make sure that the blade base is tightly
fastened to the blending jar and that the rubber gasket is properly compressed
between the blending jar and the blade base.
2. Press the lid onto the top of the blending jar. Press the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
3. Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
4. Plug in the cord. Your blender is now ready to use.
• Note: The rubber gasket on the blade base is not removable.
Stir Stick
Lid Lid Cap
Blending Jar
Dispensing Valve
Motor Base
Rubber Gasket
Blade Base
5
To Next Page
Loading...
Need help?
General
