Backyard Play Systems 5027 - Swing Beam and Monkey Bar Assembly

34
SWING BEAM SWING HANGERS
Lock Nut
Cap
1-3/8"
Washer
2 Threads MIN.
Use a socket
wrench to tighten
Lock Nut securely
against washer.
Place Cap on threads
after tightening
Swing Hanger Bolt must protrude at least
TWO Threads beyond Lock Nut.
IMPORTANT!
Lock Nut
1-3/8" Washer
HOLD position of
Swing Hanger while
tightening Lock Nut.
Final position of each Spring Clip is
perpendicular to swing beam.
Swing Beam
IMPORTANT!
x1
3-3/8 x 5-3/8 x 95"
2502-CC
UPRIGHT INSTALL
EQUAL
EQUAL
Center 2539-CC. Mark and Pre drill 7/16" through holes for hex bolt.
x1
2539-CC
1 x 3-1/2 x 47"
SWING BEAM
SUPPORT
2505-CC
1-3/4" Hex Bolt
Flush
x2
T-Nut
Flat Washer
Lock Washer