The pump belt tensioner is located under the engine and has
a grease fitting at its pivot point. Grease at every engine oil
c
The
deck belt tensioner is located at the rear of the deck and
has a grease fitting on its pivot point. Grease at every engine
o
SECTION 5: FRAME
T
orque rear wheel
lugs
to
65
-75
ft. lbs.
R
e-torque
at
every
o
i
l c
h
ange and
check
at every mowing.
There is
one
grease fitting o
n
each
of the
actuator
bar pillow
b
locks (
T
o
t
al o
f 4).
Gr
e
a
se twice a season.
The pump belt tensioner is located under the
engine and has a grease fitting at its pivot point.
Grease at every engine oil change.
The deck belt tensioner is located at the rear of
the deck and has a grease fitting on its pivot
point. Grease at every engine oil change.
top of each block. Grease one time a year.
Grease fittings on MZ model total – 8
SECTION 6: CUTTING DECK
The control arm blocks have grease fittings
located on the top of each block. Grease one time
a year
8
o
Gr
r l
ea
ef
se
l
fitt
t blade pul
ings on MZ model total -
ey cover. (5) Wh
ile lifting up on the belt (as
shown in the photograph), rotate the pulley until the belt is
free of the pulley. Exercise caution while performing this step
as fingers can easily become caught between the belt and
PAGE 32
To Next Page
Loading...
Need help?
General
