Bad Boy RENEGADE Series Service Manual

PAGE 24
SPARK PLUG
CHANGING THE SPARK PLUGS AND CHECKING THE
SPARK PLUG GAP
Reference engine owner’s manual for spark plug
locations.
1. Remove the spark plug cap and use an
appropriate socket to remove the spark plug.
2. Check the gap of the spark plug by using a feeler
gauge and set gap to the recommend value in
the engine’s service manual.
3. If the spark plug is worn, overheated, wet or
carbon-fouled replace the spark plug.
4. Install the plug into cylinder head and torque to
the recommended specifications in engine’s
service manual. Be careful not to overtighten the
spark plug.
Spark Plugs
Spark Plug
Spark
Plug Wire
Fig. 21
Fig. 22
Fig. 23

Bad Boy RENEGADE Series Specifications

General

Spindle Material	Cast Iron
Horsepower	37 HP
Cutting Width	72 inches
Transmission	Hydro-Gear ZT-4400
Cutting Height	1.5 - 5 inches