7
BF-UM-C-DP C260-EN November 2019
USER MANUAL FOR DISPLAY
7.6.5 Walk Assistance
When your Pedelec is motionless, briefly press button until the Walk assistance indicator is
displayed. At this point, long press button, the Pedelec enters the walk assistance mode, the in-
dicator will flash. If release the button will stop this, if no any operations within 5s will automatically
return to 0 level. That is stopped from the Walk assistance mode.(as following)
7.6.6 Battery Capacity Indication
The percentage of current battery capacity and total capacity is displayed from 100% to 0% accord-
ing to the actual capacity (as shown in the figure below)
7.6.7 SERVICE
HMI will prompt for maintenance according to the mileage and battery charger times. When mileage
exceeds 5000km (100 times for charger) and the "Service" function is enabled, the "SERVICE" indica-
tion will be flash displayed at every time for 5s, then enter into the main interface. This function can
be set in the interface. For the operation is detailed in the following text.
To Next Page
Loading...