BAHAG JHS-A019-07KR2/E - Exhaust Hose Installation

63
Figure
4
Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the hole of the
window sealing
plate assembly (as shown in Fig.5 and Fig.6) .
Notes
：
1
、
the flat end of the exhaust pipe joints must be snapped into place.
2
、
The pipe cannot be distorted nor has substantial turning (greater than 45
°
).
Keep the ventilation of the exhaust pipe not blocked.
Figure
5
Figure
6
Important Notice:
The length of the exhaust hose shall be 280~1,500mm, and this length is based on the