What to do if my Baileigh Industrial Equipment machine overloads and won't bend?
If your Baileigh Industrial Equipment machine overloads and won't bend, check the following: Ensure the material's wall thickness and diameter are within the machine's capacity. Consider using material with lower tensile strength. Reduce the bending speed. Also, verify that the input power is correct and that the counter die is lubricated.
Why am I getting poor bend results with my Baileigh Industrial Equipment?
If you are experiencing poor bend results with your Baileigh Industrial Equipment, you should replace the worn counter die or the worn die groove. Verify that the material size and wall thickness are correct. Also, check the clear radius (CLR).
What to do if material slips in hook arm of Baileigh Industrial Equipment?
If the material slips in the hook arm of your Baileigh Industrial Equipment, start by cleaning the material and die groove with a solvent. Increase the clear radius and the wall thickness of the material. Consider clamping the material to the top hook arm to prevent slipping, and ensure only the counter die is lubricated.
Why is my Baileigh Industrial Equipment twisting material?
If your Baileigh Industrial Equipment is twisting material, make sure that the bend die is securely bolted to the spindle and that the counter die is properly aligned. If the issue persists, the spindle bearing may need to be replaced.
How to troubleshoot power issues with Baileigh Industrial Equipment?
If your Baileigh Industrial Equipment is not powering up, check the input power source to ensure it's correct and providing the right voltage. Inspect and replace any blown fuses, and reset any tripped circuit breakers.
Why is my Baileigh Industrial Equipment producing inaccurate bending?
If you're experiencing inaccurate bending with your Baileigh Industrial Equipment, verify that the counter die leadscrew is holding its position using the counter. Also, use a caliper to check the material diameter and ensure it's consistent.
What to do if home position is not in correct position in Baileigh Industrial Equipment?
If the home position of your Baileigh Industrial Equipment is not in the correct position, go to the homing screen on the controller and repeat the homing sequence. If the homing screen is not accessible, contact the factory.
Why is oil leaking from the breather of my Baileigh Industrial Equipment?
If you notice oil leaking from the breather of your Baileigh Industrial Equipment, it's likely due to the normal expansion of gearbox oil. Allow the oil to purge from the gearbox, and no further action should be needed.
Details on defects, warranty period, claims, and exclusions.
Defines DANGER, WARNING, CAUTION, and NOTICE signal words.
Warning against placing body parts in the die area.
Warning about high voltage and lockout procedures.
Numbered safety tips for operation.
Prohibition of operating under influence of alcohol or drugs.
Critical safety warning before connecting power.
Requirement for certified electrician for power connection.
Introduction to the touch screen operator interface.
Initial machine startup and homing procedure.
How to create and save bend programs.
Practicing operations without material installed.
Warning regarding potential material hazards.
Critical safety warning for maintenance tasks.
Diagram of the base assembly components.
General| Brand | Baileigh Industrial |
|---|---|
| Model | MPB-275 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
