To Next PageTo Next Page
Need help?Do you have a question about the Baileigh BS-916M and is the answer not in the manual?
Secure the machine to the floor using bolts or tie rods.
Steps for installing the control box.
Steps for installing the bow lift handle and hand wheel.
Install the material stop rod and contact assembly.
Steps for installing the motor, belt guard, and belt.
Cautions regarding electrical connections and grounding.
Guidelines for selecting and using extension cords.
Essential checks before operating the saw.
Safety guidelines while the saw is running.
Process for new blade break-in and chip indicators.
Interpreting chips for proper feed rate and saw speed.
Factors to consider when selecting a saw blade.
Table for selecting the correct blade based on material and size.
Essential checks and guidelines before operating the saw.
Procedures for powering on and off the saw.
Steps to prepare the saw for cutting a workpiece.
How to set the blade guide brackets for optimal cutting.
Adjusting the vise for positioning and angle cutting.
Regulating the descent speed for optimal cutting.
Procedure for changing the blade speed settings.
Adjusting the micro switch for automatic shut-off.
Setting the clearance for thrust rollers.
Adjusting the guide rollers for blade movement.
Adjusting the blade to track correctly on the wheels.
Steps for removing and installing a saw blade.
Procedure for draining and refilling the gear case oil.
Diagram showing the layout of the electrical panel.
General
