Bailey Approach Advance - Page 52

Leisure & Vehicle Battery Voltage
This screen shows the voltage of the
currently selected battery as set on
the “Select Battery” screen. If a
230V mains supply is connected
then the charging voltage of the
Leisure battery will be displayed.
An estimate of your batteries’ remaining
charge can be seen by pressing
then .
12V or less reads 0%, and 12.7V or more reads
100%. You can return to displaying the voltage
by pressing then .
To increase accuracy of the battery voltage
reading, switch the “Master Switch” off.
Note: See “Notications and Warnings”
section for low voltage warnings and the “User
Settings” section the Low Volts alarm enable.
User Settings
Press to access the “User
Settings” screen.
See below for a description of each
option.
Navigation
1. You can scroll through the settings with the
and buttons.
2. To edit a setting, highlight it then press
to change.
3. If there are several options you may need to
use the
and buttons to change value.
4. Press
to accept new value.
5. To exit, scroll to “Exit to main menu” and
press .
Settings
Contrast
Adjusts the contrast of the LCD display if you
are nding it difcult to read.
Sound
Enables or disables the sound when a button
is pressed
Chg V Batt
When enabled the vehicle battery will be
charged while 230V mains is connected. The
leisure battery will also be charged at the same
time.
Standby
Sets how long the control panel waits for a
button press before going into standby.
Water Low
Enables or disables the warning alarm when
the water tank is low.
Press
to acknowledge an alarm that has
triggered.
The warning will only re-arm when the water
level increases by 25%.
Waste High
Enables or disables the warning alarm when
the waste tank is high.
Press to acknowledge an alarm that has
triggered.
The warning will only re-arm when the waste
level is reduced to 50%.
230V Lost
Enables or disables the warning alarm when
the 230V mains connection is lost.
Press to acknowledge an alarm that has
triggered.
The warning will only re-arm when the 230V
connection is restored.
Amps High
Enables or disables the warning alarm when
the current drawn from the leisure battery
exceeds 12A.
Press to acknowledge an alarm that has
triggered.
The warning will only re-arm when the current
is reduced below 5A.
Veh Batt Low
Enables or disables the warning alarm when
the vehicle battery voltage is less than 11V.
Press
to acknowledge an alarm that has
triggered.
The warning will only re-arm when the vehicle
battery is charged over 13V.
Leis Batt Low
Enables or disables the warning alarm when
the leisure battery voltage is less than 11V.
Press
to acknowledge an alarm that has
triggered.
The warning will only re-arm when the leisure
battery is charged over 13V.
Auto Battery
When enabled the power source will switch
to vehicle battery automatically if the leisure
battery is low. When a charging voltage is
detected, the power source will switch back to
leisure battery.
49
6
FITTED EQUIPMENT – The Control Panel
FITTED EQUIPMENT – The Control Panel