To run vehicle on Petrol mode :
• Put Selector switch in Petrol mode.
• Wait for some time for filling of the Carburettor bowl.
• Crank the engine.
Important Tips for ‘Cold Starting’
For easy ‘Cold Starting’ i.e first time in the morning or after 3 or 4 hours of parking when the engine
becomes cold, it is recommended to start the engine only on ‘PETROL’ and then switch over to GAS as
follows :
1. With On / Off switch on ‘ON’ put the switch on (Petrol) mode position selector
2. Use choke and start engine. On starting the engine, release the choke immediately.
3. Warm-up the engine and run the vehicle on petrol for 2 to 4 minutes i.e. For 3 to 5 kms.
4. To switch over engine to GAS put the selector switch on OFF mode position while engine is running.
On feeling slight jerk at engine put selector switch to GAS mode position.
5. Ensure engine gives proper response to throttle. If engine fails to respond, repeat the procedure as
mentioned at point no. 4
CAUTION
While switching from petrol to gas mode, put the Selector switch in OFF position. Run the vehicle till
the petrol in Carburettor is consumed. Then switch over to gas position. Also adjust the idling speed if
required.
!
51
To Next Page