Always ensure piston ring position.
•
Open end facing towards exhaust.
•
Open end facing towards inlet.
•
Open end 30 facing towards exhaust.
•
Open end 30 facing towards inlet.
•
Open ends at center and joints butting together facing down.
Top Ring :
Second Ring :
Upper Rail :
Bottom Rail :
Expander :
0
0
When tightening the special nut for centrifugal filter the Primary gear holder
should hold between the ‘Primary Gear’ and ‘Clutch Housing’ from bottom
side. (Note that oil pump assly is removed).
When loosening the special nut for ‘Centrifugal Filter’ the Primary gear holder
should be hold between the ‘Primary Gear’ and Clutch Housing’ from upper
side.
Never rest the Rotor holder against Gear change pedal lever.
IMPORTANT POINTS TO REMEMBER
Pulsar 150/180 DTS-i
Service Station Manual
98
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
