REMOVAL OF ENGINE FROM FRAME
Remove :
•
While removing engine foundation bolts, first remove the topmost bolt and
then go down progressively.
Note : Bolts (A) holding the engine to the chassis. (4 bolts of 12 mm and 1 bolt
needs deep socket for removing it).
• Lift up the engine off the chassis and place it on engine stand.
Note : After disconnecting all the sub assemblies and control cables from the engine
lift up the engine and remove it from RHS of the vehicle.
Remove :
• Disconnect the reed switch coupler.
• Spark plug cap LH
• PCV pipe from breather
Pulsar 150/180 DTS-i
Service Station Manual
101
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
