REMOVAL OF ENGINE FROM FRAME
Remove :
• Air filter mounting bolts to facilitate the removal of carburettor with
reed switch.
• Clamps of carburettor and disconnect carburettor along with
insulator and dismantle cables from it.
• Bracket bolts securing clutch cable on clutch cover.
• Spark plug cap RH
Remove :
• 2 nuts for silencer flange(B)
Note : Always remove the flange mounting first and then rear mounting to avoid
misalignment of studs.
Using Special Tool : Sprocket Holder -
37 1030 53
Remove :
• Bolts (A)
• Plate drive sprocket
• Drive sprocket along with the chain.
• Neutral switch coupler .(B)
A
B
B
Remove :
• Bolt of silencer bracket mounted on pillion RH side footstep.
• Silencer assembly.
(A)
Remove :
• Starter motor connection (A)
A
A
Pulsar 150/180 DTS-i
Service Station Manual
100
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
