SOP FOR DISMANTLING ENGINE
Note : The rod clutch lifter, plunger oil, plate plunger oil and spring
joint may fall out of their respective places into the oil collection tray.
If so, ensure that these are collected & accounted for before
proceeding.
Remove :
• 12 Clutch cover bolts
• Bracket clutch cable
(B)
(C)
Note : The rod clutch lifter, plunger oil, plate plunger oil and spring joint may fall out
of their respective places into the oil collection tray. If so, ensure that these are
collected & accounted for before proceeding.
Remove :
• 2 Dowels
• Clutch cover gasket
• Starter Motor (B)
A
Remove :
• 1 screw -
• Starter motor cover
(A)
A
C
B
B
Engine RH : Clutch Side
Using Sp. Tool : Primary Gear Holder 37
10DJ 28
Remove :
• 3 phillips head screws (A)
• Centrifugal oil filter cover
• Gasket
Note : Some amount of oil is trapped in cover
and body of centrifugal oil filter, this oil should be drained into the oil tray.
Pulsar 150/180 DTS-i
Service Station Manual
116
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
