ASSEMBLY - ENGINE
Pulsar 150/180 DTS-i
Service Station Manual
133
Dealer Development Center
Akurdi Pune
Use Bearing Driver set (P. No. 37 1030 73)
Fit :
• Bearing for Input Shaft
Note : Do not use inner guide while fitting the bearing for ‘Input Shaft’ in ‘Crankcase
LH’ as this will damage the protruding lug of crankcase casting. Sealed bearings
must face crankcase side / protruding lug side.
Use Bearing Driver set (P. No. 37 1030 74)
Fit :
• Bearing for Body Balancer Gear Assembly
Use Bearing Driver set (P. No. 37 1030 61)
• 'O' ring on Guide Starter Assembly
• Damper
Fit :
• Oil seal on Guide Starter Assembly
Fit :
• Oil seal for Output Shaft
To Next Page
Loading...
