Bajaj pulsar DTS-i - Page 174

SOP FOR FRONT FORK DUST SEAL & OIL SEAL REPLACEMENT
• Remove bolt securing front brake hose clamp by 8 mm T spanner
• Remove 2 nos bolts securing caliper assembly by 12mm ring spanner.
• Remove
a. Axle nut by 22mm ring spanner.
b. Remove bolt holding front axle firmly on outer tube by 13mm ring
spanner.
c. Take out front axle.
Pulsar 150/180 DTS-i
Service Station Manual
170
Dealer Development Center
Akurdi Pune
fºT b[\k his kl[Àpn[ 8 ni Ap[nr Wiri Ki[li[mm 't'
k[l)pr a[s[Àbl)n[ 12mmni r)>g Ap[nr Wiri b[bi[ÃTn[ Ki[li[
kiQi[
a[ksln) 22n>brn) nTn[r)g Ap[nrn[Wiri
fºT a[ksl n[ pkDvi miT[n) nTn[ 13mm r)>g Ap[nr Wiri Ki[li[
aigLn) a[ks[ln[ bhir kiQi[